looking for suitable laboratory equipment?

Our professionals are available 24*7. You can call us any time.

To understanding
Influence of stabilising agents on the properties of liposomal ...

Influence of stabilising agents on the properties of liposomal ...

Aug 14, 2019 Characteristics of liposomal encapsulated ethanolic coconut husk extract (LE-ECHE) as influenced by different stabilising agents (SA) were investigated. LE-ECHE was prepared using four liposome formulations including soy phosphatidylcholine (SPC) alone and SPC mixed with cholesterol (CHL), tween 80 (TWE) or glycerol (GLY) at a ratio of 4 : 1 as ...

More Product
Liposomal resiquimod for the treatment of Leishmania

Liposomal resiquimod for the treatment of Leishmania

Aug 16, 2013 The lipid solution was rotary-evaporated with a Buchi R-200 rotary evaporator (New Castle, DE, USA) and a Buchi B-490 water bath set at 60C. Lipids were reconstituted in H 2 O for 30 min in a 60C water bath. Liposomes were freeze-thawed three times, followed by extrusion through an Avanti Mini-Extruder/Heating Block with an 80 nm ...

More Product
Rotary Evaporators Fisher Scientific

Rotary Evaporators Fisher Scientific

Bump Trap, 250mL, Rotary Evaporator, Modified, 24/40 Top Outer, 14/20 Lower Inner. Similar to CG-1320, but with the addition of two 4mm drain holes at the base of the inner tube to allow solvent to drain back into the evaporation flask. Traps have a 24/40 top outer joint and the listed size of lower inner joint.

More Product
rotary evaporator liposome

rotary evaporator liposome

DEVELOPMENT AND CHARACTERIZATION OF LIPOSOMAL DRUG . methods ethanol injection method and rotary evaporator technique The average particle size percent drug entrapment drug release at the end was found to be 270‐703 49‐58 and 65 71 in case of ethanol injection method while in case of rotary evaporator it was found to be 1‐12 181 m 69‐86

More Product
Food Research International - UMinho

Food Research International - UMinho

evaporated in a rotary evaporator at 50C. The extracts were filtered and clarified with 10mL of 0.1M barium hydroxide and 10mL of 5% zinc sulfate. The solutions were filtered and quantitatively transferred to a volumetric flask of 50mL, and the final volume was completed with water. 2.3.1. Quantification of phenolic compounds

More Product
What is a Rotary Evaporator? -

What is a Rotary Evaporator? -

Feb 14, 2022 Rotary evaporators (rotovaps) are devices employed for removing solvents efficiently via the process of evaporation. The rotary evaporation process is one of the most widely used methods of solvent evaporation due to its optimal extraction and distillation performance. Rotary evaporators are also used for concentration, crystallization, drying ...

More Product
A Simple And Efficient Method For Radiolabeling Of Preformed Liposomes

A Simple And Efficient Method For Radiolabeling Of Preformed Liposomes

Liposome Preparation. The hydrogenated soy phosphatidylcholine , cholesterol and phospholipid distearoyl-phosphatidylethanolamine were gifts ... The mixture was placed in a round-bottom flask and the solvent was removed under negative pressure using a rotary evaporator.

More Product
rotary evaporator ppt liposome

rotary evaporator ppt liposome

Liposomes LinkedIn SlideShare. nbsp 0183 32 Liposome were first produced in England in 1961 by Alec D Bangham The size of a liposome ranges from some 20 nm up ii The resulting mixture is then transferred to a round bottom flask RBF which is attached to a rotary evaporator and rotated at 60rpm iii evaporation of organic solvent at 30 ͦc or above the

More Product
Temperature- and rigidity-mediated rapid transport of lipid ...

Temperature- and rigidity-mediated rapid transport of lipid ...

Mar 05, 2019 The mixtures were evaporated to dryness in a rotatory flask on a rotary evaporator and then hydrated with deionized water/saline solution (2 mL) for 30 min using a vortex. The hydration temperatures of the liposomes are listed in SI Appendix, Table S1. Finally, the liposomal preparations were extruded through 400-, 200-, and 100-nm ...

More Product
In vitro stability and content release properties of

In vitro stability and content release properties of

Oct 01, 2007 Liposomes were prepared by the lipid film hydration and extrusion method .The composition of the different formulations used in this study are given in Table 1.Respective lipids were dissolved in chloroform using a round-bottomed flask, and the solvent was evaporated under vacuum in a rotary evaporator until a thin and homogeneous lipid film was formed.

More Product
Preparation and Characterization of Tea Polyphenols

Preparation and Characterization of Tea Polyphenols

Preparation and Characterization of Tea Polyphenols and Vitamin E Loaded Nanoscale Complex Liposome

More Product
Glycerosomes: Advanced Liposomal Drug Delivery System

Glycerosomes: Advanced Liposomal Drug Delivery System

Sep 06, 2019 The dispersion is then added to a rotary evaporator for removal of organic solvent at stated conditions i.e. reduced pressure, 20-25 and 200 rpm. ... Liposomal formulation for dermal and transdermal drug delivery: past, present and future. Recent Pat Drug Deliv Formul 2008;2:9-18. Rani D, Singh C, Kumar A, Sharma VK. Formulation development ...

More Product
International Journal ofPharmTech Research

International Journal ofPharmTech Research

solvent was evaporated by reduced pressureusing rotary evaporator to yield a thin lipid film inside the round-bottomed flask. Solvent evaporation was prolonged to 60 minutes to remove all solvent. The thin lipid film was ... Liposome formulations from soybean extract can be done using pure phospholipids,16,17 or unpurified soybean lecithin.18 ...

More Product
Rotavapor R-300

Rotavapor R-300

The Rotavapor R-300 meets the highest expectations of convenience and versatility in rotary evaporation. Its modular design allows the R-300 to be extended to a fully integrated system where a central interface regulates each component. Evaporating flask size: 50 – 5000 mL. Lift mechanism: Manual or automatic. Temperature range: 20 – 220 C.

More Product
Latest News
X

CONTACT US

If you are interested in our products, please contact us, your satisfaction is our eternal pursuit!